ABS filament at the hive?

General
1

A while ago, Bill bought a large amount of 3mm ABS filament in an auction and donated some to Hive. Where did that end up? I’d like to use it to print and enable hand and a few other things on the ultimaker (got training from Lorin).

I imagine it probably needs to be dehydrated for good printing…

Thanks,

Mike

2

Coy showed me where it is.
Mike

3

It’ll print as is, but it’ll do better after an overnight dehydrate (won’t pop, smoother). Just put the heat in the middle of the dial and plug it in. You can take out the nylon filament I had in there last.

L